How to install the blade of the coaxial cable stripping machine

　　Installing the blade on a coaxial cable stripping machine typically involves a few key steps.

　　1. Turn Off the Machine: Ensure that the machine is turned off and unplugged to avoid any accidents during the installation process.

　　2. Access the Blade Area: Open the blade compartment or access panel of the machine. This may involve removing screws or latches depending on your machine's design.

　　3. Remove the Old Blade: If there is an old blade in place, carefully remove it. This usually involves loosening screws or bolts that hold the blade in place.

　　4. Install the New Blade: Align the new blade with the mounting holes or slots. Make sure it’s positioned correctly according to the machine’s design. The blade should be sharp side out and properly aligned with the cutting mechanism.

　　5. Secure the Blade: Tighten the screws or bolts that hold the blade in place. Ensure that the blade is securely fixed and there is no wobbling or play.

　　6. Adjust the Blade: If your machine has adjustment settings for blade depth or angle, adjust them as needed to ensure proper stripping performance.

　　7. Close the Access Panel: Replace and secure the access panel or cover.

　　8. Test the Machine: Plug the machine back in and perform a test run with a piece of coaxial cable to ensure that the blade is cutting properly and that the machine is functioning as expected.

　　9. Check for Safety: Make sure all safety guards and features are properly in place before operating the machine.

　　Always refer to the specific user manual for your coaxial cable stripping machine for detailed instructions, as the procedure may vary depending on the model and manufacturer.