How to realize automatic crimping of coax cables

        Automatic crimping of coaxial cables can be realized by using WG-9002D coaxial cable termination tinning machine, which is mainly realized in the following steps.

        Step 1, is the automatic feeding of the coaxial cable, the WG-9002D Coaxial Cable Termination Tinning Machine automatically transports the entire coil of coaxial cable to the processing station of the machine to realize the overall automation process. After the whole roll of cable is used up, you only need to pause the machine and load a new roll of cable into the machine.

        Step 2, is automatic stripping and cutting. This model can cut the wire to a fixed length and perform the stripping operation on both ends of the wire bundle through the stripping mechanism in the front section.

        Step 3, visual correction. The equipment will visually inspect each wire harness, for the next step of the operation for the good product, the bad product record and directly put down to the NG position

        Step 4, in coordination with the robot, the machine will transport the coaxial cable to the terminal crimping station, the end of the terminal crimping.

        Step 5, stick flux and dip tin. The robot will work on the other end of the cable without crimped terminals by sticking rosin water (or other flux) and dipping tin water.

        Step 6, automatic sorting. The machine will place the NG position for the defective products in the whole process, and the good products will flow into the good product pool, which greatly saves the time and cost of manual sorting.
         Well, the automatic crimping of coaxial cable is introduced here, more product knowledge, please bookmark us.